StreamLight

Spec sheet

Product

StreamLight is a Moonlight fork with a gamepad-first interface and integration with the StreamTweak host companion.Read 11 Oct 2026 · github.com

Integrations

The project describes optional Philips Hue Sync support and branded tile artwork for the Windows 11 Xbox app’s “My apps” section.Read 11 Oct 2026 · github.com

Security

The StreamTweak bridge signs commands with the client’s Moonlight identity certificate and requires one-time host approval using a four-digit PIN.Read 11 Oct 2026 · github.com

Support

The repository includes a “Support the Project” heading but states no support channel in the visible README text.Read 11 Oct 2026 · github.com

License

StreamLight is released under the GPL v3 License.Read 11 Oct 2026 · github.com

Additional host features

Paired features include Tailscale address handling, store badges for Steam, Epic, GOG, Ubisoft, Xbox, Battle.net, and EA App, and an optional shared clipboard.Read 11 Oct 2026 · github.com

Clipboard

Optional shared clipboard transfers text up to 32 KB using a key that lasts one stream; copied passwords are cleared on the receiving side within 60 seconds.Read 4 Oct 2026 · github.com

Clipboard security

The shared clipboard is off until enabled and encrypts text with a key that lasts for one stream; its stated limit is 32 KB.Read 11 Oct 2026 · github.com

Compatibility

It runs on Windows 10 and 11 and works as a Moonlight-compatible client with Sunshine, Apollo, Vibeshine, and Vibepollo hosts.Read 11 Oct 2026 · github.com

Controls

The interface supports gamepad navigation, keyboard controls, and configurable keyboard hotkeys and controller shortcuts.Read 11 Oct 2026 · github.com

Download

The installation instructions direct users to download the latest installer from the project’s GitHub Releases page.Read 11 Oct 2026 · github.com

Host integration

With StreamTweak installed on the host, StreamLight offers host metrics, session quality reporting, remote power controls, and Windows Update management.Read 11 Oct 2026 · github.com

Install and updates

The README directs users to download the latest installer from GitHub Releases and says in-app updates check downloads against a GitHub checksum.Read 4 Oct 2026 · github.com

Interface

The interface is designed for gamepad navigation, with keyboard access and configurable shortcuts.Read 4 Oct 2026 · github.com

Notable limits

The PyroWave codec requires hundreds of Mbps and a Vibeshine or Vibepollo 2.0 host.Read 11 Oct 2026 · github.com

Profiles

Users can create up to three named profiles per host and set per-game overrides.Read 4 Oct 2026 · github.com

Remote access

Tailscale integration can track LAN and Tailscale addresses for a host on one tile and optionally use the Tailscale endpoint.Read 4 Oct 2026 · github.com

Stream controls

While streaming, users can change resolution, frame rate, bitrate, HDR, and frame pacing; custom resolutions and frame rates are supported.Read 4 Oct 2026 · github.com

Stream settings

Users can adjust resolution, frame rate, bitrate, HDR, and frame pacing while streaming.Read 11 Oct 2026 · github.com

Streaming

Its streaming engine uses FFmpeg, D3D11VA, DXVA2, libplacebo, and moonlight-common-c.Read 11 Oct 2026 · github.com

Where Specifiction places it

• Game Remote Play Software#23 of 276.7